Yes — a self-cleaning iron remover can handle wet, sticky ore, because water does not reduce magnetic force. Blinding is a mechanical adhesion problem: wet fines stick to the cleaning belt, pulleys and chute. With a doctor blade, low-pressure return-side spray, correct belt speed and weekly wash-downs, capture and discharge stay reliable even above 8–10% moisture.
|
Item |
Description |
|
Function |
Continuously removes tramp iron from a conveyor carrying wet, sticky ore without manual cleaning |
|
Material |
Permanent ferrite or rare-earth magnet circuit; PU or stainless steel cleaning belt; PU/tungsten-carbide scraper |
|
Application |
Iron ore, copper ore, gold ore, coal, nickel laterite and aggregate lines with moisture between 6% and 15% |
|
Main wet-ore risk |
Mud layer on belt, pulleys and chute; iron falling back onto the conveyor |
|
Service life |
Magnet circuit 10+ years; cleaning belt 2–5 years; scraper blades 3–12 months |
|
Key benefit |
No operator per shift for magnet cleaning; stable crusher protection in wet conditions |
![]()
Q1: Does water weaken the magnet in a self-cleaning iron remover?
No. Magnetic force is unaffected by moisture, whether the unit is permanent or electromagnetic. Wet-ore failures come from mud adhesion on belts, pulleys and chutes, not from any loss of field strength. Specify scraper and wash features instead of a stronger magnet.
Q2: At what moisture level does belt blinding usually start?
Most plants report trouble between 8% and 10% moisture when the ore is rich in minus 2 mm clay fines. Above roughly 12%, blinding becomes continuous unless a scraper, return-side spray and steeper chute are fitted. Coarse wet lump ore with few fines rarely blinds.
Q3: Should I speed up the cleaning belt to shed mud?
No — slowing the belt usually works better. Slower travel lengthens contact time on the magnet pole and gives the scraper more effective passes. Excessive speed drives mud into the belt surface and accelerates blade wear.
Q4: Can a scraper be added to my existing overband magnet?
In most cases yes. A field-adjustable PU blade mount can be retrofitted at the discharge point if the belt frame has room. Ask the supplier for a drawing based on your machine's belt width and pulley diameter; blades are consumables, so order several.
Q5: Is a magnetic drum better than an overband for wet sticky ore?
For thin beds at conveyor discharge, a drum is often superior because its shell wipes continuously against a fixed scraper, so mud cannot accumulate on a moving loop. For deep, high-tonnage beds over the belt centreline, an overband with scraper and spray remains the practical choice.
Q6: How often should pulleys and idlers be washed in wet ore?
Weekly during wet seasons, plus after rainfall events. A mud ring of about 5 mm on an idler is an early warning; at 10 mm the belt will start tracking off. Inspect tracking under normal load, not on an empty belt, because load position changes contact.![]()
Contact: Annie Lu
Email: annie.lu@huataogroup.com
Phone / WhatsApp: +86 180 3242 2676
Website: http://www.tufflexscreen.com
We warmly welcome customers from around the world to contact us and establish mutually beneficial partnerships.
Contact Person: Mr. Maple
Tel: +86 17778255675
Fax: 86--311-80690567