Manufacturing screw flights for horizontal TMR mixers requires attention to flight geometry, material and forming method. The correct process depends on the original mixer design and whether the auger uses individual flight sections or continuous spiral flighting.
For individual spiral sections, a single-piece hydraulic screw flight forming machine can be considered. It presses separate blade sections into the required spiral shape.
However, the machine should be selected according to the actual flight dimensions and material—not just the largest diameter.
Start by checking the original mixer auger design.
Is the flight made from separate spiral sections or one continuous spiral? How are the sections connected to the shaft? Are there special edge shapes or different pitches along the auger?
These details influence the manufacturing route. A sectional hydraulic press is not automatically the right choice for every continuous flight design.
The material should match the mixer manufacturer's specification and the expected working conditions.
The forming-machine brochure lists carbon steel, 304 stainless steel, 201 stainless steel and HARDOX steel as processable materials.
For TMR mixer applications, do not select a material based on its name alone. Consider the feed ingredients, moisture, operating frequency, wear conditions and original component design. The final grade should be confirmed by the mixer design requirements.
There are three different production methods to consider.
Hydraulic pressing: Suitable for evaluating individual flight sections. A mould presses each section into the required spiral shape.
Continuous cold rolling: Forms continuous flighting through a rolling process. This is a different solution from pressing individual sections.
Winding: Forms spiral blades by winding strip material. It is another separate process and should be selected according to the product structure.
The correct method depends on the flight design, production quantity and required dimensions.
Before selecting a hydraulic forming machine, confirm:
Inner diameter: The opening at the center of the flight.
Outer diameter: The finished overall diameter.
Thickness: The steel plate thickness.
Material: The exact steel grade.
Pitch: The axial distance between adjacent turns.
These five specifications are sufficient for an initial machine model assessment. A complete drawing is not necessary at this stage.
If the flight has a special profile or non-standard connection, a drawing or sample can help with the later technical confirmation.
Different machine models have different forming ranges.
For example, the available machine brochure lists HT240, HT280 and HT330 models with different thickness, pitch and diameter ranges. The HT330 is listed for plate thickness of 2–50 mm and an outer diameter below 2400 mm.
These are individual catalogue limits. The actual combination of diameter, thickness, pitch and material must be evaluated before confirming a model.
The purchase decision should include long-term maintenance.
Our machine is supplied with a one-year warranty. Its expected service life can reach approximately 7–8 years under suitable operating and maintenance conditions.
The equipment has very few wearing parts. Replacement parts are inexpensive and easy to change, helping reduce the difficulty of routine maintenance.
Actual service life depends on operating conditions and maintenance practices.
Which forming method is best for TMR mixer screw flights?
It depends on the design. Hydraulic pressing can be evaluated for individual flight sections. Continuous rolling or winding may be more suitable for other flight constructions.
Can the machine form large spiral blades?
Larger models are available, but the required OD must be checked together with ID, thickness, pitch and material.
Can stainless steel or HARDOX be formed?
Both are listed in the machine brochure as processable materials. The exact grade and dimensions need to be confirmed.
Do I need to provide a drawing?
No. Five basic specifications are enough for the initial selection.
Can the machine be customized?
Machine selection and configuration can be discussed according to the required flight size and material.
If you are manufacturing horizontal TMR mixers or replacement auger flights, begin with the five basic details: ID, OD, thickness, material and pitch.
These details help determine whether a single-piece hydraulic screw flight forming machine is appropriate for your production.
Contact Info:
Email:lucychai0315@gmail.com
Whatsapp/Wechat:+86 15373883537
Website:www.refinerdisc.com
Contact Person: Mr. Maple
Tel: +86 17778255675
Fax: 86--311-80690567