Thick steel screw flights—generally above 14 mm, or any wear-resistant grade—require a single-section hydraulic screw flight forming machine (a flights screw forming machine) . Continuous cold-rolling is limited to thinner strip. The selection hinges on three engineering facts: the base frame must be solid and fully welded to survive high-tonnage recoil; hydraulic tonnage must be rated for the specific material grade, not just thickness; and the tooling must control springback and cracking without becoming a rapid-wear consumable.
Cold-rolling forms a helix by passing strip through rollers. It is efficient for thin material and high-volume output, but it cannot generate the localized force needed for thick plate. When plate thickness moves beyond the rolling envelope, hydraulic single-section forming is the appropriate process. A cylinder drives a die into a plate blank, bending it to the required helix in one press cycle. The die defines the geometry, and the process accommodates thick carbon steel, stainless steel, and wear-resistant grades such as Hardox and NM400.
A thick-plate hydraulic press does not merely apply force; it absorbs recoil. The entire frame is subjected to cyclical, high-tonnage loading. Manufacturers seeking to reduce steel cost may use a hollow or skeletal base frame. Under continuous thick-plate work, that frame deflects. The deflection transfers to the main shaft, producing pitch drift, bearing distress, and hydraulic leaks. Structurally compromised machines often develop these symptoms within 1–2 years of heavy use.
A solid reinforced base, fully welded with internal multi-column supports, resists that deflection. The rigidity is what preserves alignment between the die and the shaft over years of operation, and it is the engineering basis for a 7–8 year service life under heavy loads. This is a specification a buyer can and should verify—through workshop photographs of the base before assembly, not through a brochure claim.
Thickness alone does not determine force requirement. A machine rated for 12 mm mild steel may fail to form 20 mm Q345 or 12 mm Hardox. Higher-strength plate demands more tonnage, and it also exhibits greater springback. The press and die must be designed to over-bend the material so that it relaxes into the correct final helix. A supplier who quotes capacity without asking for your material grade and pitch geometry is providing an incomplete answer.
A wear-resistant plate is susceptible to edge cracking if forming is too abrupt. The die must allow gradual deformation, and the tooling steel must be selected and heat-treated for the pressure involved. On a correctly matched machine, the tooling is a durable component that wears gradually under normal load. It is not a high-frequency consumable. The practical distinction for a buyer is this: on an undersized or structurally weak machine, the tooling absorbs the consequences of frame deflection and wears prematurely. On a machine specified for the actual work, tooling life is predictable, and replacement parts—when eventually needed—are inexpensive and straightforward to change.
Thick-plate forming operates near the upper edge of a machine’s capability envelope. Choosing a catalogue model by “maximum thickness" alone is therefore unreliable. The sound approach is to specify the machine around the production requirement: blade outer diameter, inner diameter, pitch, material grade, and annual volume. Tonnage, die envelope, and frame specification should be adjusted to that combination. A supplier capable of that adjustment is offering a matched solution; one who cannot is selling an approximation.
Thick steel flights are a force-management problem. The correct machine category is single-section hydraulic. The structural prerequisite is a solid, welded base. Selection must be driven by material grade, springback behaviour, and tooling durability rather than a headline thickness figure. A machine built on those principles provides years of stable production with low-cost, easy-change spare parts.
Contact Info:
Email:lucychai0315@gmail.com
Whatsapp/Wechat:+86 15373883537
Website:www.refinerdisc.com
Contact Person: Mr. Maple
Tel: +86 17778255675
Fax: 86--311-80690567