Payment & Shipping Terms:
|Manufacturing Proces:||Casting||Material:||Stainless Steel|
pulp tester laboratory,
lab pulp tester
Stainless Steel Pulp Tester Wally Beater
1.Stainless Steel Pulp Tester Wally Beater mainly introduction
The Valley beater is one of the most commonly used beating equipment in the laboratory.
Composed of a mountain-shaped part, a flying knife roll, a bed knife bed, a pressurizing mechanism, etc.
Under use, changes such as cutting, crushing, swelling, and fibrillation occur, so that the pulp can meet the requirements of papermaking.
2, Stainless Steel Pulp Tester Wally Beater Features
Materials in contact with water are stainless steel, resistant to rust and corrosion;
Equipped with double self-locking protection device to avoid accidents;
Equipped with back flushing device, easy to clean;
Rotary arm lever is used to raise and lower the bottom knife to reduce operator workload;
Equipped with an automatic beating time control system, which can precisely control the beating time
3,Stainless Steel Pulp Tester Wally Beater data sheet
|Beating amount||200～700g (standard beating amount: 360g absolute dry pulp, concentration: 1.57%)|
|Flying knife roller size||φ194×155mm|
|Speed of flying knife roller||(8.3±0.2) s-1; (500±10r/min)|
|Flying blade||thickness 4.7mm, 32 pieces|
|Bottom blade||thickness 3.2mm, 7 pieces|
|Load of lever arm||(54±1) N|
|Motor||0.55kw, 1400 rpm, 380V/50HZ|
4,Stainless Steel Pulp Tester Wally Beater feature
All components in contact with the slurry are made of high-quality stainless steel with good corrosion resistance.
The fly blade and the bottom blade are heat-treated to improve the hardness and wear resistance. The inlay blade can be replaced after wear.
The knife roller cover and the pulp groove are along the widened side, and the seal is more tight.
Contact Person: Maple
Tel: +86 15103371897